粗大的内捧猛烈进出看视频,久久久久久久高潮精品亚洲,国产玉足榨精视频在线,国产媱片在线观看,国产一区二区内射最近更新-亚洲av午夜精品无码专区-国产亚洲日韩欧美另类-久久久国产99久久国产一 ,国产无遮挡吃胸膜奶免费看_精品人妻一区二区三区_中文字幕av人妻一区二区_波多野结喷水最猛一部352 ,麻豆精品国产自产在线观看_国产大屁股喷水视频在线_中文字幕第一页在线无码_免费无码又爽又刺激高潮久久

An annealing process:
Annealing is generally electrical contact, electrode annealed round (touch wheel) will even import the high-current copper wires, copper wire to achieve the preheating and heating. Preheating is copper wire heated to high temperature oxidation will not, generally 250 degrees; heating is heated to annealing temperature copper wire, usually 500 to 550 degrees, so that recrystallization heating section with steam protection against copper oxidation, then after water cooling, the complete annealing (softening) process.
Second, the technical requirements:
1, annealing speed and voltage and pull-up speed should be kept synchronized.
2, annealing and annealing current is proportional to the square of diameter, wire size should be set according to current annealing. Soft annealed copper wire to ensure performance meets GB3953 requirements or desired performance.
3, up tension line storage device by adjusting the pressure of the cylinder.
4, copper wire of diameter deviation should be consistent with the provisions of GB3953.
Third, the narrow diameter of the reasons:
copper produced in the process of drawing hardening, annealing soften, reduce the tensile strength of copper wire, plastic and elongation increase. In the closing line tension under the effect of narrowing the diameter is inevitable. However, should control the diameter of narrow scope, generally not more than 0.02mm (determined according to the size of diameter). If the take-up tension decreases, annealed copper wire between the wheel will shake, poor contact, the phenomenon of emergence points spark, is easy to break and accelerate the annealing wheel damage. Therefore, the choice should be based on the size of diameter up tension.
Four measures:
will reduce the amount of wire, to the aperture on the sizing die.